How to compost with fertilizer machine?

As an important mechanical equipment in the fermentation process of biological fertilizer project, the dumper needs more attention in the use process in order to be better used and bring higher income.

1. Check whether the oil circuit system and smooth system of the dumper are unblocked. If it is not unblocked, immediately notify the maintenance personnel for maintenance.

2. Check whether the amount of oil in the upender oil tank is satisfactory. If not, add enough. Check whether the hydraulic system leaks;

3. Before starting the stacker, carefully check whether the organization of each part is intact and whether the positioning of each transmission handle and shift handle is accurate and inaccurate. You should also carefully maintain the smooth operation of the machine as required.

4. Operators must be present before going to work.

5. Before starting the stacker, the rolling part of mechanical energy shall be rolled. Investigate whether the machine has abnormal rolling, and notify the maintenance personnel to repair in time.

6. When starting the stacker, first turn on the power switch to energize the machine, and then turn on the switch of electric oil pump and each motor for trial operation. After the operation of the rail changer stops, operate on the upper rack.

7. During the operation of the dumper, if abnormal conditions such as spindle vibration, loud noise, or high pressure and high temperature exceeding 65 ° C are found, it shall be handled and checked with the technician immediately;

8. Except for the maintenance and repair carried out by relevant personnel during the operation of the dump machine, other personnel shall stop the machine.

9. If there is a problem with the dumper, immediately inform relevant personnel to find out the cause and eliminate the problem. It is not allowed to deal with it without authorization. It is forbidden to operate the equipment with disease.

10. After the operation of the upender, turn off the fan and let the drum run for 2-3 minutes. Desilting can be carried out before shutdown. After that, the tipper shall be cleaned, ironed and dedusted, oiled smoothly, and the power supply shall be blocked.